Verilink 8100A (34-00237) Product Manual - Manual (Page 109)

C o n f i g u r a t i o n 4-35
Configure Fragmentation
1 On the Frame Relay Options menu, type “1” to display the Frame Relay
Fragmentation Configuration menu (Figure 4.53).
Figure 4.53 Frame Relay Fragmentation Configuration Menu
2 Type “1” to select Configure FRF.12 Fragmentation and proceed to
FRF.12 configuration.
− or −
Type “2” to select Copper Mountain Fragmentation and proceed to
CopperMountain Fragmentation configuration.
Each of these configurations is described below.
Frame Relay FRF.12
Configuration
Select FRF.12 Fragmentation to display the FRF.12 Configuration menu
(Figure 4.54).
Figure 4.54 FRF.12 Configuration Menu
Each option on this menu is described in detail below.
Enable/Disable FRF.12
To enable or disable FRF.12, follow the steps below.
1 Type “1” on the Frame Relay FRF.12 Configuration menu. The IAD
displays FRF.12 Fragmentation status (enabled or disabled), and prompts
you to change it.
2 Type “E” to enable End-to-End fragmentation, or type “D” to disable it.
The IAD saves the configuration and displays the FRF.12 Configuration
menu. Press Escape to continue.
Enable Automatic Fragment Sizing
Type “2” on the Frame Relay FRF.12 Configuration menu to enable
automatic fragment sizing. The IAD saves the configuration and displays the
FR FRF.12 Configuration menu. Press Escape to continue.
Set Manual Fragment Size
To manually set the Fragment Size, follow the steps below.