Verilink 8100A (34-00237) Product Manual User Manual
Page 91

C o n f i g u r a t i o n
4-17
Figure 4.21
Configure S-Bits Menu
Configure Loopback
Type “4” on the E1 Configuration menu to select Configure Loopback,
which will display the menu shown in Figure 4.22
Figure 4.22
Select Loopback Configuration
The Payload Loopback loops the data after the E1 framer back to the network.
The Line Loopback loops the data before the E1 framer back to the network.
The Local (Inward) Loopback loops the data after the E1 framer back to the
user.
Configure Active
Channels
Type “5” on the E1 Configuration menu (Figure 4.19) to select Channel
Configuration menu (Figure 4.23). Use this menu to determine which DS0s
have data.
This manual is related to the following products:
- 8108 Series IAD (34-00339.B) Product Manual 8508 Series IAD (34-00339.B) Product Manual 8208 Series IAD (34-00339.B) Product Manual 8308 Series IAD (34-00339.B) Product Manual 7500p Series IAD (34-00334.B) Product Manual 7200p Series IAD (34-00334.B) Product Manual 7000 Series (34-00334) Product Manual