Verilink 8100A (34-00237) Product Manual - Manual (Page 122)

4-48 8 0 0 0 S e r i e s
2 Type “E” to enable DHCP Relay on this port, or “D” to disable it.
3 The IAD displays the current DHCP server IP address and prompts you to
enter a new address.
4 Type the new DHCP Server IP address. The IAD saves the changes and
displays the Router Configuration menu (Figure 4.59).
5 Continue with other configuration tasks, or press Escape to return to the
Main menu.
Configure DHCP
Relay
To configure the DHCP Relay, follow the steps below.
1 On the DHCP Relay menu, type “C”. The IAD displays the current IP
address and prompts you to enter a new address.
2 Type the new DHCP Server IP address. The IAD saves the changes and
displays the Router Configuration menu (Figure 4.59).
3 Continue with other configuration tasks, or press Escape to return to the
Router Modification menu.
Display DHCP Relay
Statistics
To display information about DHCP, follow the steps below.
1 Type “S” on the DHCP Relay menu (Figure 4.63). When DHCP Relay is
enabled, the IAD displays a report such as the one below.
2 Press any key to return to the DNS Client menu when you have finished
reviewing the information.
Configure Telnet Server Port
When using NAT on the IAD, you may want to configure a host behind NAT
as a Telnet Server. In this case, Telnet requests are passed to the host, and not
handled by the IAD. By changing the Telnet port, both the host and IAD may
be accessed via Telnet.
To set the port for the Telnet Server, follow the steps below.
1 On the Router Configuration menu (Figure 4.59), type “T” to select
Configure Telnet Server Port. The IAD displays the current IP address and
prompts you to enter the new Telnet Server port.
2 Type the new Telnet Server port (the default is 23). The IAD saves the
changes and displays the Router Configuration menu (Figure 4.59).
3 Continue with other configuration tasks, or press Escape to return to the
Main menu.