Verilink 8100A (34-00237) Product Manual - Manual (Page 108)

4-34 8 0 0 0 S e r i e s
1 On the Frame Relay DLCI Configuration menu, type “2” to select Modify
Existing DLCI.The IAD displays the port table and prompts you to select
the appropriate port as shown in
Figure 4.51 Modify Existing DLCI Menu
2 Type the port number corresponding to the DLCI you want to update and
press Enter.
3 Type the new DLCI number and press Enter. The IAD displays the Frame
Relay Encapsulation Configuration menu as shown in Figure 4.48.
4 Continue with the steps listed above under “Adding a new DLCI.”
Delete DLCI To delete a DLCI, follow the steps below.
1 On the Frame Relay DLCI Configuration menu, type “3” to select Delete
DLCI. The IAD displays the port table and prompts you to select a port.
2 Type the port number corresponding to the DLCI you want to delete. To
permanently remove the DLCI configuration, type “Y”. To cancel the
operation, type “N”.
Show Current DLCIs To display all currently configured DLCIs, follow the steps below.
1 Type “4” on the Frame Relay DLCI Configuration menu to display the port
table.
2 Press any key to display the Frame Relay DLCI Configuration menu.
Configure Frame Relay Options
To configure Frame Relay options, type “4” on the WAN Configuration
menu. The IAD displays the Frame Relay menu (Figure 4.52).
Figure 4.52 Frame Relay Options Configuration Menu
Each of the menu options is described in detail below.