Verilink 8100A (34-00237) Product Manual - Manual (Page 88)

4-14 8 0 0 0 S e r i e s
1 Type “5” on the T1 Configuration menu (Figure 4.14) to select the
Channel Configuration Menu (Figure 4.17). Use this menu to determine
which DS0s have data.
Figure 4.17 Channel Configuration Menu
−
T1
Each option on this menu is described in detail below.
Enable All Channels
Type “1” to enable all channels for traffic.
Disable All Channels
Type “2” to disable all channels for traffic.
Toggle Individual Channels
Type “3” to toggle channels on which to configure individual DS0s for traffic.
Add Channel Range
Type “4” to enable a range of channels on which to configure DS0s for traffic.
NOTICE: The Channel Configuration menus options 5, 6, 7, 8, and S described
below are only accessible on the 8208 and 8208s units.
Auto Detect DS0 On Boot
Type “5” to automatically search for active DS0s immediately upon system
boot or reboot when the WAN has detected the carrier as “up.”
Auto Detect DS0 After Carrier Fail
Type “6” to automatically search for active DS0s every time the T1/E1 carrier
has dropped and re-synced. For this option, the T1/E1 carrier can be physically
interrupted or the service provider can send AIS. Either will cause the T1/E1
framer to lose frame sync and initiate a DS0 search.