Verilink 8100A (34-00237) Product Manual - Manual (Page 93)

C o n f i g u r a t i o n 4-19
1 Type “P” on the T1/E1 Configuration menu (Figure 4.14) to display the
physical layer statistics and the alarm log.
Figure 4.25 Sample Physical Layer Stats and Alarm Log:
2 Enter any key to continue paging through the report; press Escape to cancel
and return to the T1/E1 Configuration menu.
Clear Physical Layer
Stats
Type “Z” on the T1/E1 Configuration menu (Figure 4.14) to clear all
Physical Layer statistics.
Configure Physical Interface
−
ADSL
The tasks described in this section all begin on the ADSL Configuration menu
(Figure 4.26). You should review and update each of these options as
necessary, and always reset the IAD when you finish ADSL configuration.
To configure the ADSL interface, Type “1” (Configure Physical Interface)
on the WAN Configuration menu (Figure 4.5) to display the ADSL
Configuration menu.
Figure 4.26 ADSL Configuration Menu
NOTICE: The options you see on the ADSL Configuration menu depend on the
specific DSLAM.