Verilink 8100A (34-00237) Product Manual - Manual (Page 216)

5-32 8 0 0 0 S e r i e s
Type “A” on the Reports menu to display the information shown in the table
below about mappings between Ethernet Media Access Control (MAC)
addresses (hardware addresses) and IP addresses.
Bridge Forwarding Database Report
To display information about mappings between Ethernet addresses and
devices connected to the LAN, type “B” on the Reports Menu. The IAD
displays the report shown in the table below.
You must enable bridging for this information to display. For more
information on enabling bridging, refer to Bridge Configuration Menu on
page 4-55.
Bridge Status Report
To display information about bridging, type “S” on the Reports Menu. The
IAD displays a record for each interface as shown in the table below.
Parameter Description
IP Address IP address that corresponds to the MAC address
Ethernet Address Ethernet address of the device; assigned by the
manufacturer
Age Timer Seconds until the ARP entry expires
State Incomplete, Complete, and Expired
Interface The interface for the Ethernet address
Parameter Description
Ethernet Address Ethernet address of the device; assigned by the
manufacturer
Interface Interface for the Ethernet address
Port Port for the Ethernet interface
Timer No. of seconds until this entry deletes from the
database. The time counts down from the bridge
database aging time value, in one-second intervals; at
zero, the entry deletes from the database
Parameter Description
Interface interface for the active slot for bridging
Port port for the preceding interface
Spanning Tree Protocol (STP) enable | disable
State Spanning tree state: disabled | blocking | listening |
learning | forwarding
Root root port for the bridge—yes | no