Verilink 8100A (34-00237) Product Manual - Manual (Page 233)

C o m m a n d L i n e I n t e r f a c e 6-13
set voip codec
remove
Removes VoIP codec from the codec advertised list.
set voip codec remove (G729a|G726|uLAW|ALAW|2833|NSE)
G729a | G726 | uLAW | ALAW | 2833 | NSE
List of possible codec selections. ALL selects every available codec.
set voip debug Sets the VoIP debug message output level.
set voip debug <1-3>
set voip line
password
Enables a password for POTS line used for VoIP.
set voip line password (|all)
line-number | all
Determines which POTS line(s) is used.
password
Passwords are case-sensitive.
set voip line
prefix
Configures a name (phone number) or a phone line on an IAD.
set voip line prefix
line-number
Defines a line: values are from one to a maximum number of lines.
prefix
Identifier for a line (phone number).
set voip rtp
connection
Configures IP address that will be used to send and receive voice RTP traffic.
set voip rtp connection [ [ [
[]]]]
set voip rtp port
start
Configures a starting RTP port on which voice data is sent and received. First
phone line on an IAD will use it. Each following line will use a port number
two higher.
set voip rtp port start
port-number
Defines starting RTP port.
set voip server Configures FQDN or IP address of a SIP proxy.
set voip server (|)
server-name | ip-address
Defines a SIP proxy.
set voip
signaling
connection
Configures IP address used for SIP signaling and is used to identify a user to
a SIP proxy.
set voip signaling connection [ [
[ []]]]