Ppp authorization entries report, System uptime report, Memory statistics reports – Verilink 8100A (34-00237) Product Manual User Manual
Page 217

R e p o r t s
5-33
The spanning state timer value is for listening or learning states and counts
down from the forward delay time to zero.
The hello timer value is valid only if the active port is the Root Bridge of the
network. It counts down from the hello time to zero.
•
Root priority
− priority of the root bridge on the network.
•
ID
− Ethernet MAC address of the root bridge on the network.
Press any key to return to the Reports menu.
PPP Authorization Entries Report
Type “P” on the Reports menu to display information about PPP
authorization entries. If no PPP authorization entries have been created, the
IAD displays a message to confirm this.
Otherwise, the information shown in the table below is displayed for each
entry.
Press any key to return to the Reports menu.
System Uptime Report
Type “U” on the Reports menu to display the amount of time elapsed since
the IAD was reset.
Press any key to return to the Reports menu.
Memory Statistics Reports
Type “O” on the Reports menu to display the Memory Statistics menu. The
Memory Statistics menu (1-O) contains two memory display commands:
Designated
designated port for the bridge—yes | no
Timers
current values of the spanning state timer (first
value) and the hello timer (second value)
Parameter
Description
Parameter
Description
Authorization type
None | Password Authentication Protocol (PAP)
Client | PAP Server |Challenge Handshake
Authentication Protocol (CHAP) Client | CHAP
Server
Slot #/Interface #/Port #
active slot for the PPP interface
Userid/Password/Peer Name
values for the PPP interface
- 8108 Series IAD (34-00339.B) Product Manual 8508 Series IAD (34-00339.B) Product Manual 8208 Series IAD (34-00339.B) Product Manual 8308 Series IAD (34-00339.B) Product Manual 7500p Series IAD (34-00334.B) Product Manual 7200p Series IAD (34-00334.B) Product Manual 7000 Series (34-00334) Product Manual