Comtech EF Data SDM-300L3 - Manual (Page 73)

SDM-300L3 Satellite Modem Revision 1
Front Panel Operation MN/SDM300L3.IOM
4–5
Press [ ↑ ] or [ ↓ ] to change the parameters. After the display represents the correct
parameters, press [ENTER] to execute the change. This action initiates the necessary
programming by the modem.
To undo a parameter change prior to execution, press [CLEAR].
Notes:
1. Figure 4-3 list the front panel menu window selections.
2. Comtech EF Data recommends that selection of the desired Modem Type be
made prior to making any other setting. This procedure is located in the Utility
Modem Type menu.
3. Menus or commands that are specific to certain modem configurations are only
accessible after selecting the appropriate modem configuration. This prevents
incompatible parameters from accidentally being selected.
4. All of the windows are accessible in the Custom mode. Take caution not to select
incompatible parameters, as the modem does not shut out incompatible command
choices in the Custom mode.
4.4.5 REVISION EMULATION
To program an emulation mode from Version X.X.X through the current version, use the
revision emulation feature in the Utility: Modem Type menu.
Software Version # Firmware # Rev. Description of Change
2.1.12 FW/8460-1 M Original issue
2.1.22 FW/8460-1 AA Incorporated engineering changes
2.2.1 FW/8460-1 AD Incorporated Duplex Reed-Solomon