Comtech EF Data SDM-300L3 - Manual (Page 398)

SDM-300L3 Satellite Modem Revision 1
Remote Control Operation MN/SDM300L3.IOM
A–46
Card #3
Options/
Misc.
Information Command:
Response:
>add/C3OI_'cr'
RS_02 list:
s,INTELSAT'cr'
s,AUPC'cr''lf']
RS_03 list:
s,INTELSAT'cr'
s,AUPC'cr''lf']
TURBOlist:
Duplex Reed-Solomon
s, Intelsat’cr’
s, ‘AUPC’cr’’lf’]
(- or +)
(- or +)
(- or +)
(- or +)
(- or +)
(- or +)
Notes:
1. Card #3 Installed Only.
2. s = - (Not Installed, FAST Upgradable).
3. + (Installed).
Serial
Number Command:
Response:
>add/SNUM_'cr'
MODEM_xxxxxxxxx'cr'
CARD_1_xxxxxxxxx'cr' (Note
1)
CARD_2_xxxxxxxxx'cr' (Note 2)
CARD_3_xxxxxxxxx'cr''lf'] (Note 3)
Where: xxxxxxxxx = Serial number 000000000 to 999999999.
Notes:
1. Data is only returned if Card #1 is installed.
2. Data is only returned if Card #2 is installed.
3. Data is only returned if Card #3 is installed.
State Of
Product Command:
Response:
>add/SOP_'cr'
add'cr'
abc'cr'
rrrrr bps'cr'
'cr'
'cr''lf']
Product Address
Data Format
Baud Rate
Comm Type
Where: abc = Explained below.
a = Number of data bits (7).
b = Parity type (O, E, N).
c = Number of stop bits (2).
rrrrr = baud rate ("150", "300", "600", "1200", "2400",
"4800", "9600", "14.4K", "19.2K").
= Variable length strings explaining
communication hardware type "RS-485, 2 wire", "RS-485,
4 wire", "RS-232".
= Variable length strings explaining the
intention of the product. "Under normal system operation",
"REFLASH of BULK firmware required", "REFLASH of
M&C firmware required".