Comtech EF Data SDM-650B - Manual (Page 231)

SDM-650B Satellite Modem Remote Control Operation
Rev. 6 B–55
B.2.8 Status Commands/Responses
B.2.8.1 Configuration Status
B.2.8.1.1 Modulator/Coder Configuration Status
The Modulator/Coder configuration status command causes a block of data to be returned
by the addressed modem. The block of data reflects the current configuration status of the
Modulator/Coder.
Command:
Response: >add/MCS_”cr”
RF_xxx”cr”
RF Output (ON/OFF)
MF_nnn.nnnn”cr” Modulator Frequency
MPO_snn.n”cr” Modulator Power Offset
MOP_snn.n”cr” Modulator Output Power
MR_nnn_mmmm.m”cr” Modulator Rate
AMRA_nnn_mmmm.m”cr” Filter “A” Assignment
AMRB_nnn_mmmm.m”cr” Filter “B” Assignment
AMRC_nnn_mmmm.m”cr” Filter “C” Assignment
AMRD_nnn_mmmm.m”cr” Filter “D” Assignment
SE_xxx”cr” Scrambler Enable (ON/OFF)
COM_xxx”cr” Carrier Only Mode (ON/OFF)
DENC_xxx”cr” Differential Encoder (ON/OFF)
TC_xxx”cr” Transmit Clock (INT/EXT)
AMRV_nnn.mmmm.m”cr””lf”] Modulator Variable Rate Assignment
(Variable Rate Option Only)