Comtech EF Data SDM-650B - Manual (Page 212)

Remote Control Operation SDM-650B Satellite Modem
B–36 Rev. 6
B.2.3 Modulator Configuration Commands
B.2.3.1 Set Modulator Frequency
Command:
Response: >add/MF_nnn.nnnn”cr”
RF_OFF”cr””lf”]
Status Only: Response:
>add/MF_nnn.nnnn”cr””lf”]
Where: nnn.nnnn = 50.0000 to 90.0000, and 100.0000 to 180.0000 for the
140 MHz modulator.
Note: When modulator frequency is changed, the RF output is switched OFF.
B.2.3.2 Set RF Output
Command:
Response: >add/RF_xxx”cr””lf”]
Status Only: Response:
>add/RF_xxx”cr””lf”]
Where: xxx = ON or OFF.
B.2.3.3 Set Modulator Power Offset
Command:
Response: >add/MPO_snn.n”cr””lf”]
Status Only: Response:
>add/MPO_snn.n”cr””lf”]
Where: snn.n = +20.0 to -20.0, in 0.5 dB increments.
Notes:
1. This will be the highest modulator power that will be displayed and programmed.
2. Use the MOP_ command to change the modulator output power.