Avery Dennison Monarch 9864 Description of Commands - Manual (Page 96)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
96
u = (void) as u = W.
= W (Default setting) No update. The time is read into the variable once. This is
done during the compilation of the layout.
= U The time is read repeatedly during the running print job. This happens
immediately after printing the relevant output field (#VW…), but counts only
for the same field on the next label.
The setting is not suitable for dispensers.
Reason: If the next label is printed considerably later (e.g. in single-start
mode with footswitch), the following happens: The output field on label 2
contains the time, at which the same field on label 1 was printed.
Example
Single-start mode Label 1 is printed at 10.50 h, label 2 at 11.03 h. In this case, the imprint of
label 2 shows the time 10.50!
= Y (Only group H - recommended for dispensers) The time is read repeatedly
during the printing of a label (approx. all 5 seconds).
opt. k = Snum Fixed distance in mm between all characters in TEXT. The character S has
to be succeeded without blank by the value.
opt. f = F (Only group E) Field designation for exchanging data
(see description of exchanging data)
opt. o = (blank) The current date is printed.
= 0 The current date is printed.
= int Days offset: The current date is calculated forward by the number of days
entered (1 to 65000).
= Mint (Only group H) Months offset: The current date is calculated forward by the
entered number of months (1 to 65000).
(Adding the letter M to the integer value changes the offset from day to
month!)
TIME = Time:
Times are marked with the control character (^).
= ^ z 1/100 seconds (not with group H: "^ z" always leads to "00" printout)
= ^ s seconds
= ^ m minutes
= ^ h hours
= ^ D day of the month
= ^ d (Only group H) day of the year
= ^ W (Only group H) 3-figure day (e.g. 001 for the 1 st day of the year)
= ^ M month
= ^ Y year, two digit
= ^ R year, four digit
= ^ G 3-figure month, German
= ^ E 3-figure month, English
= ^ S Name of a month from command #DM
= ^ C (Only group H) Week of the year always with two digits
= ^ c (Only group H) Week of the year without leading 0
= ^ K (Only group H) Corresponding year to the week (of the year) with 4 digits
= ^ k (Only group H) Corresponding year to the week (of the year) with 2 digits