Avery Dennison Monarch 9864 Description of Commands - Manual (Page 53)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
53
L
#LC Initialising logo card
Definition The logo card (SRAM card) in the slot is erased and initialised. A reset is
then carried out automatically.
All of the data on the logo card is erased.
New logos can be transmitted to the card with the command #DK .
Syntax #LC Groups D (without TTX 207), E, G
Example #LC Logo card is initialised and a reset is carried out.
#!A1 Printer switched to on-line mode, incoming commands are
processed.
...
#Q.../
M
#M Magnification factor
Definition This command enables characters and logos to be magnified in the X/Y
axis by the defined factor (1 to 8).
All characters which follow are magnified by the defined factor until
#M1/1has been sent, the printer reset or a new label series started.
Command must stand between #ER and #Q!
Syntax #Mx/y All groups
x = int Magnification of the font width (run direction)
Groups A, B, D, E, G
1 to 8
Group H 1 to 16
y = int Magnification of the font height
Groups A, B, D, E, G
1 to 8
Group H 1 to 16
Example
#M1/1 Characters are printed normally.
#M2/4 Characters are magnified by a factor
of 2 in the X axis and by a factor of 4
in the Y axis.
#M4/1 Characters are magnified by a factor
of 4 in the X axis and are printed
normally in the Y axis.