Avery Dennison Monarch 9864 Description of Commands - Manual (Page 50)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
50
opt. g = C Check valid tag (for Alien tags only, read EPC and compare with Alien
pattern that marks valid tags “A5A5”) - On alien tags there is an EPC
written by Alien. If this EPC begins with Hex A5A5 it is a "good" one (good
performance/good quality). If it does not start with A5A5 it means it is NOT
a "good" one. But anyway you may be able to write and read these tags.For
the purpose of eliminating these tags we check for A5A5 and if there is no
A5A5 we invalidate these tags (cross out).
= D Detect whether there is a tag to operate on. Applies to tags without UID.
Detected identification is treated internally as UID. Do not use this option if
you would like to operate on zero initialized EPC tags (they cannot be
detected). This is default value.
= N none
opt.
d = int Distance in print direction (x) from label edge to optimum of transponder
antenna.
It is recommended to set parameter y to R when parameter d is used. This
parameter is mandatory for any RFID processing (even if distance is zero).
opt. e = int Number of retries with different tags in case of detect errors. Default
defined by parameter “Max tags to stop”. Range from 0 to 10.
opt. f = V verify option (default: don’t’ verify) - Verify written data with an extra read
after write and compare it. If written data and read data is different an error
is reported
opt. h = int Distance to middle of chip from label edge, to activate head lift for chip
protection. With h option we define an explicit range of head lifting. Even if
there is something to print we lift the head - nothing is printed and chip is
protected.
Examples #IMS50/100/TYP1 Gapped material, 50 mm wide, 100 mm long,
TYPE 1
#IMN20/50/ Reel material, 20 mm wide, 50 mm long
#IMSR98/165///70 Gapped material, 98 mm wide, 165 mm long,
with RFID transponder; 70 mm distance from
label edge to middle of transponder antenna,
autodetect transponder type
print direction
d
chip
h