Avery Dennison Monarch 9864 Description of Commands - Manual (Page 54)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
54
#ME Eject material
Definition
•
Cuts the label material off.
•
The printer ejects the label material by moving it backwards.
The command #MOF may only be sent outside of a format #ER to #Q/.
Use this command only for printers equipped with a cutter!
The command does not work in label formats for standalone mode!
Syntax #ME Group H
#MOF Material end detection Off
Definition Deactivation of the sensor for detecting the material end.
The command #MOF may only be sent outside of a format #ER to #Q/.
Syntax
#MOF Group D
#MOF = Deactivation of the material end detection.
Default setting for the material end detection is "activated". The value is
stored in the NOVRAM.
#MON Material end detection On
Definition Activation of the sensor for detecting the material end.
If the sensor is deactivated, the printing process must be stopped manually
at the end of a roll, otherwise the print roller could be damaged.
The command #MON may only be sent outside of a format #ER to #Q/.
Syntax
#MON Group D
#MON = Activation of the material end detection.
Default setting for the material end detection is "activated". The value is
stored in the NOVRAM.
Example #MON The material end sensor is activated.
#ER ...
#YB0/0/10////12345678