Avery Dennison Monarch 9864 Description of Commands User Manual
Page 105
10/07 Rev. AA
MANUAL EASY PLUG
Commands
All
devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
105
opt.
n = Y
Unterdrückung führender Nullen bei Zählfeldern. Die restlichen Ziffern
werden an derselben Position gedruckt, an der sie mit führenden Nullen
stehen würden.
Example
(n)
#YN100/0Y/1/1//Test000#G Printout: Test 1, Test 2, …, Test 10, etc.
opt. j
=
M Middle:
The write command (#T/#J) refers to the centre of the text field. The field is
built up on both sides of the print position.
=
R
Flush
right:
The write command (#T/#J) refers to the right edge of the text field. The
field is built up to the left.
opt.
f = F
Field designation for changing data
(see description of changing data)
opt.
w = W
Counter field TEXT is incremented/decremented without a carry over, i.e.
only the first unit position of the figure is increased/decreased.
opt.
c = Dint
Rotation of TEXT in steps of one degree (0 to 359 degree);
Default setting: 0 degree; The character D has to be succeeded without
blank by the value. Parameter c takes priority over d.
opt. g
=
O Default
type
=
B
Bold
opt. h
=
V Default
type
=
I
Italics
opt.
r =
The same as "K"
= K
Application of scalable fonts without Unicode (default setting)
= U
Application of Unicode fonts.
Each Unicode-character has to be referred to in the TEXT-field as follows:
\u0041
(example with 0041 being the index of the character "A").
See below for an example of a #YN command using Unicode (example 2).
There are some specific features to bear in mind, when using Unicode
fonts!
To read more about using Unicode, refer to topic section "General Notes,
Definitions and Command Overview", chapter "Easy Plug and Unicode".
opt.
k = Snum Fixed distance in mm between all characters in TEXT. The character S has
to be succeeded without blank by the value.
opt.
p = N
(Default) Standard character-algorithm is applied.
Q
2 D character algorithm is used. May improve the exactness of small
characters. (e.g. printing of small chinese characters). This algorithm is
about 30-40% slower than the standard algorithm.