Avery Dennison Monarch 9864 Description of Commands - Manual (Page 62)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
62
#PIN Pin on activation/deactivation
Definition Command #PIN activates and deactivates the pin module. The printer can
be used as a conventional printer if the pin module is deactivated.
The command must be sent before the command #IM!
Syntax #PINn Group D (only Pin On)
n = int
= 0 Pin module deactivated
= 1 Pin module activated
#PO Gap offset
Definition This command is for determining the beginning of the label when irregularly
formed labels are being printed.
Command must stand outside of #ER and #Q!
Syntax #POva Groups A, D, E, G, H
#POva/s Group B
v = + Positive offset: label begins before the end of the gap
= - Negative offset: label begins after the end of the gap
a = num Offset in mm:
Observe the limitations of the printer concerned, see User Manual.
opt. s = int Gap length:
Only necessary if labels in bone form are being processed which have the
following parameters: gap length >3 mm (reel material) or 15 mm (gapped
material).
Zero-position groups B, C, D, E, F, G, H
Zero-position group A
Feed
- Offset + Offset