Avery Dennison Monarch 9864 Description of Commands - Manual (Page 82)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
82
opt. p = N (Default) Standard character-algorithm is applied.
Q 2 D character algorithm is used. May improve the exactness of small
characters. (e.g. printing of small chinese characters). This algorithm is
about 30-40% slower than the standard algorithm.
e = int Font size in dot in y-direction, depending on the font and its installed size,
respectively (see example below). Value range: [5…6000] Dot.
e = Xint Font size in dot in x-direction, depending on the font and its installed size,
respectively (see example below). Value range: [5…6000] Dot.
The character X has to be succeeded without blank by the value “int”.
Example
#SS100/0/120X99///Speedo Test#G The text „Speedo Test“ has font
size 120 in y-direction and font
size 99 in x-direction.
b = int Micro spacing measured in printhead dots. The value is added to the
standard character distance and allows fine adjustment of the text width.
Value range [0…16].
#SV Changing the content of a text variable
Command is allowed between or outside #ER and #Q!
Syntax #SV/name/TEXT#G Group H (without AP 4.4)
name = Variable name (must be defined with #VDT before!)
TEXT = New value of the variable