Avery Dennison Monarch 9864 Description of Commands User Manual
Page 77
10/07 Rev. AA
MANUAL EASY PLUG
Commands
All
devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
77
#
Bar code
#
Bar code
8
CODABAR
22
CODE 2/5 Matrix Ratio 1:3
9
UPCE
23
CODE 39 Extended
10 ADD ON 2
24
CODE 128 A
11 ADD ON 5
25
CODE 128 B
12 ITF
26
CODE 128 C
13 CODE 128
27
CODE 128 Pharmacy
Tab. 6 Bar code selection is done by inserting the appropriate number into the #SB
command.
Printing a bar code list with print samples:
Call up parameter
PRINT INFO > Font status
.
k = M
Bar code with plain-copy line
= O
Bar code without plain-copy line
c = C
A check digit according to Module 10 is calculated and printed.
Works only with 2/5 interleaved bar codes and with ITF bar code!
= N
No check digit calculation
l = H
Plain copy line justified
= I
Plain copy line left-justified
= K
Plain copy line centered
= L
Plain copy line right-justified
Default setting depends on the barcode type.
b = A
Position change of the plain-copy line. If the plain-copy line is normally
printed below the bar code, it is shifted by this option to the top of the bar
code, and the other way round.
m = B
EAN/UCC mode with brackets around the data designator.
The data have to be sent in brackets! The brackets appear in the plain copy
line but not as bar code.
= X
EAN/UCC mode without brackets around the data designator.
Data have to be sent without brackets.
opt.
r = Pnum Ratio of the bar code (2.0 to 3.0)
The letter P (proportion) must stand immediately in front of the ratio (e.g.
P2.5). A ratio without the letter P is invalid.
opt.
e = V
Bar code is verified.
Only with connected and activated OLV.
Only applicable for bar codes which are rotated by 0° or 180°.
h = int
Bar code height:
Bar code height = (h + 1) *
PRINT PARAMETERS > Bar code multip.
0
Æ
1 mm, 1 Æ 2 mm, 2 Æ 3 mm bar code height, if parameter
PRINT PARAMETERS > Bar code multip.
is set to 1 (default).
s = int
Bar code width factor (1 to 30)