Avery Dennison Monarch 9864 Description of Commands - Manual (Page 42)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
42
#FE Material feed with cut(s)
Only with TTK/Texxtile, TTX 350/Ocelot and AP 7.t
Feeds and cuts the labels remaining between printhead and cutter at the
end of a print job. The label length defined in the last print job is used.
The command must stand outside of the command sequence #ER to #Q!
The command does not work in label formats for standalone mode!
Syntax #FE Group G, H (AP 7.t only)
#FE = Feed and cut of the remaining labels at the end of a print job.
#FF Material feed
Definition Material is fed through by one label length (only outside of a format).
With reel material: feed by a defined label length
With gapped material: feed to the next gap
"Gapped" materials are materials with positional markings (punched holes,
reflecting markings and register gaps on self-adhesive labels).
The command must stand outside of the command sequence #ER to #Q!
The command does not work in label formats for standalone mode!
Syntax
#FF All groups
#FF = Feed by one label length or up to the next gap.