Avery Dennison Monarch 9864 Description of Commands - Manual (Page 81)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
81
l = 0 Bar code width is set automatically
= int Bar code width in code words (number of columns) (1 to 30): The width
should be so selected that a height of 90 lines is not exceeded with regards
to the area of the bar code defined in the user data. A maximum of 928
code words are permitted for one bar code. Of these the following are
preassigned:
– 1 word for the length input of the code
– x words for the check total (Security Level) = 2 (1 + Security Level)
z = 0 Number of lines is set automatically
= int Number of lines (3 to 90)
w = int Bar code width (1 to 16)
h = num Height of a PDF bar code row in millimetres (1 to 100)
#SRS RSS definition
Definition of a “RSS” bar code. Printing of the bar code requires a
subsequent #VW-command.
Command must be placed between #ER and #Q!
Syntax #SRS/z/s#G Group H (without AP 4.4)
z = int Bar code number
See topic section „Info-printouts & Parameters“, paragraph „Font status“,
Bar code library“.
s = int Number of printer dots for the bar code module width.
#SS Speedo font definition
Defines the font for a scalable text field (speedo font). Printing of the bar
code requires a subsequent #VW-command.
Command must be placed between #ER and #Q!
Syntax #SSz/ghrkp/ex/s #G Group H (without AP 4.4)
z = int Font number
The fonts 100 and 101 are internal scalable fonts and are therefore always
available.
See printer manual, topic section "Internal Fonts".
g = O Default type
= B Bold
h = V Default type
= I Italics
r = K Application of scalable fonts without Unicode (default setting)
= U Application of Unicode fonts.
k = Snum Fixed distance in mm between all characters in TEXT.
The character S has to be succeeded without blank by the value “num”.