Avery Dennison Monarch 9864 Description of Commands - Manual (Page 60)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
60
#PC Setting Parameter Values
Setting of parameters in the printer menu to certain values. The function is
helpful, if…
•
settings must be transferred from one printer to another.
•
several printers are supposed to have the same settings.
•
the settings of a printer are supposed to be recovered, e.g. after the CPU
board was replaced.
It is adviseable to read out the parameter settings of the concerned device
at first. This can be done one of the following ways:
•
With the Easy-Plug command #!PG .
•
By aid of parameter SPECIAL FUNCTION > Parameter to CF .
Many of the parameters need a system reset, before the changed setting
becomes effective. This can be triggered at the printers operation panel or
by an Easy-Plug command.
Syntax #PC/#G Group H
Parameter Ident number (ID) . Each parameter in the menu has its own
Parameter-ID.
Finding out a Parameter-ID: Call SPECIAL FUNCTION > Parameter to CF . The so
generated text file contains the assignment Parameter-ID/Parameter.
999999 = Parameter-ID for special functions; must be applied in
combination with one of the below listed values (Tab. 5).
/ Separation sign
Parameter Value . The admissible values depend on the type of parameter.
Assigned values can be integer numbers, floating point numbers or strings.
The parameter values for the parameters IP address , Netmask and
Gateway address can be specified in the format xxx.xxx.xxx.xxx or as plain
integer.
Further information can be found in the command description of #!PG .
Value Function
-1 Reset
1 If the parameter SPECIAL FUNCTION > Factory settings is called, the
current parameter settings are used (equals the parameter
setting
SPECIAL FUNCTION > Default values = User defined )
2 If the parameter SPECIAL FUNCTION > Factory settings is called, the
standard factory settings are used (equals the parameter setting
SPECIAL FUNCTION > Default values = Standard )
Tab. 5 Admissible values for special functions – must be applied together with Parameter-
ID „999999“.
Example
#PC1508/viper#G Sets the FTP Server password to „viper“
(
INTERF. PARAM. > ETHERNET PARAM. >
FTP password = viper )
#PC999999/-1#G The printer will be started newly (reset)