Avery Dennison Monarch 9864 Description of Commands - Manual (Page 63)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
63
Example #PO-20 Beginning of the label 20 mm before
the end of the gap
#PO+5 Beginning of the label 5 mm after the
end of the gap
#PO Label begins at the end of the gap
#PR Print speed
Definition For setting the print speed and feed speed.
The command must stand outside of the command sequence #ER to #Q!
Syntax #PRx/y/ Groups D, E, G, H
x = int Print speed; The setting range depends on the printer type; setting
interval: 1 inch/s
y = int Feed speed; The setting range depends on the printer type; setting
interval: 1 inch/s
With DPM/ ALX 92x, decimal places may be programmed. The setting
interval then is 0.2 Inch (e.g. #PR 8.6/8.6).
Example #PR Both speeds = 8 inch/s (Default
setting)
#PR4/ Print speed = 4 inch/s,
Feed speed = Previously set value or,
if no value has been set, default
setting.
#PR/6/ Print speed = Previously set value or,
if no value has been set, default
setting.
Feed speed = 6 inch/s
#PR8/10/ Print speed = 8 inch/s
Feed speed = 10 inch/s