Avery Dennison Monarch 9864 Description of Commands - Manual (Page 24)

10/07 Rev. AA MANUAL EASY PLUG Commands
All devices
A = TTX 600 --TLX 604 – Eagle B = TTX 300 Offline -- Cobra Offline D = TTX 300 Online –TTX 207 -- Cobra Online – Da Capo
E = TTX 450/650/674/675/950/1050 – Puma/Puma plus/Lion/Lion plus/Tiger/Tiger XXL -- S45/65/95/105 -- TDI/STDI/XXTREME
G = TTX 350 – Ocelot – TTK – Texxtile H = 64-xx –Chess x –TT4 – DPM – PEM – ALX 92x – AP 4.4/5.4
24
B
#BCH Bar code height factor
Definition This command is used for magnifying the height of the bar code.
The factor relates to the height defined in the command #YB . This
command may only be sent outside of a format #ER to #Q/.
Syntax #BCHn Group D
n = int Bar code height factor (1 to 10).
Default value is "1". The bar code height factor is stored in the NOVRAM.
Example #BCH5 A bar code EAN 8 10 mm high
multiplied by the factor "5" is
transformed into a bar code 50 mm
high.
#ER ...
#YB0/0/9////12345678
#BOF Spooler buffer off
Definition
This command is used to block the interface spooler buffer. The spooler
buffer is blocked after receiving a format, and is only released after the
required number of labels has been printed.
The #BOF command is not saved in Groups A and B, i.e. this command
only remains active until the printer has been switched off or until a #BON
command is sent.
The command must stand outside of the command sequence #ER to #Q!
Syntax #BOF All groups
#BOF = Spooler buffer works in single job mode. Only one format can be sent.
#BON Spooler buffer on
Definition This command is used to activate the interface spooler buffer. It releases
the spooler buffer after it has been blocked (with #BOF).
In this mode several formats can be sent to the spooler (even during the
printing phase).
In Groups A and B the printer is always in BON mode after it is switched
on.
The command must stand outside of the command sequence #ER to #Q!
Syntax #BON All groups
#BON = Spooler buffer works in multi-job mode. Formats can be sent at all times.