Adept s600 Cobra - Manual (Page 83)

Chapter 6: Optional Equipment Installation
Figure 6-12. Removing the Cable Strap Plate
12. Remove the four screws for the Joint 1 cover and lift the cover up so you have access to
the tubing under the cover. See Figure 6-13.
Figure 6-13. Connecting Spare Air Line to User Connector
13. Disconnect the tubing from the 6 mm User Air fitting shown in Figure 6-13. Fold the
tubing out of the way and restrain using tie-wraps.
14. Locate the spare air line contained in the tubing bundle inside the front end of the
cover. Remove the spare air line from the bundle.
15. Insert the spare air line into the back of the empty 6 mm User Air fitting.
Adept Cobra s600/s800 Robot, User’s Guide, Rev L1
Page 83 of 128