Figure 6-4, Figure 6-5 – Adept s600 Cobra User Manual
Page 74
Chapter 6: Optional Equipment Installation
Figure 6-4. Internal User Connectors—OP3/4, EOAPWR, ESTOP
WARNING: When the Outer link cover is removed, you
see the label shown above. Do not remove the J3-ENC or
J4-ENC encoder cable connectors from their sockets. If
they are removed, the calibration data will be lost and
the robot must be run through a factory recalibration
process, which requires special software and tools.
Figure 6-5. SOLND Connector
Adept Cobra s600/s800 Robot, User’s Guide, Rev L1
Page 74 of 128
This manual is related to the following products: