EXFO FTB-8500 Series for FTB-200 User Manual
Ethernet and fibre channel application
This manual is related to the following products:
Table of contents
Document Outline
- Certification Information
- 1 Introducing the Ethernet and Fibre Channel Application
- 2 Safety Information
- 3 Getting Started
- 4 Physical Interfaces and LEDs
- 5 Introducing the Smart User Interface
- 6 Creating and Starting a Test Case
- Introducing the Test Setup
- Test Case Availability
- EtherSAM (Y.1564) Test Case
- Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
- Ethernet RFC 2544 Test Case
- Ethernet BERT Test Case
- Ethernet Frame Analyzer Test Case
- Ethernet Smart Loopback Test Case
- Ethernet TCP Throughput Test Case
- Fibre Channel BERT Test Case
- 7 Summary Tabs
- 8 I/F Setup Tabs
- 9 Port Tabs
- 10 WIS Tabs
- 11 Traffic Analyzer Tabs
- 12 Stream Generation Tabs
- 13 Stream Analyzer Tabs
- 14 Pattern Tabs
- 15 RFC 2544 Tabs
- 16 EtherSAM Tabs
- 17 TCP Throughput Tabs
- 18 Advanced Tab
- 19 Common Tab
- 20 Expert Mode Tabs
- 21 System Tabs
- 22 Tools Tabs
- 23 Suspend and Resume
- 24 Power Failure Recovery
- 25 Maintenance
- 26 Troubleshooting
- 27 Warranty
- A Specifications
- B Glossary
- C Pop-Up Windows
- VLAN Configuration
- PBB-TE Interface configuration
- IPv4 Configuration
- IPv6 Address Configuration
- Copy Service Network Configuration
- Service Profile Configuration
- Framing Configuration
- Frame Size Configuration
- Frame Format Configuration
- MAC Configuration
- MPLS Configuration
- UDP Configuration
- TCP Configuration
- Advanced TOS/DS
- Ping
- Advanced Ping
- Advanced Trace Route
- Filter Selection
- Truncation Calculator
- Field Match Configuration
- Triggered Frame Details
- Data Capture Export
- D Report Generator
- Index