EXFO FTB-8500 Series for FTB-200 - Manual (Page 361)

System Tabs
Ethernet and Fibre Channel Application 347
IPv6 Test Preferences
IPv6 Test Preferences
Press Main, System, Preferences, and IPv6 Test Preferences.
Note: The following configuration parameters apply to both the stream and the
interface.

(FTB-8510B)IP Version: Allows the selection of the IP version (IPv4 or
IPv6) that will be selected by default when creating a test case.
Note: The following parameters apply only to IPv6 even when IPv4 is selected as
the default IP Version. See Default/Ethernet Test Preferences on page 344
for more information on IPv4 parameters.

Link-Local IPv6 Address: The Link-Local IPv6 Address (LLA) is used
for local communication between on-link neighbors and for Neighbor
Discovery process.
Mode

Stateless Auto allows automatic generation of the IPv6 address
based on the MAC address. The mode Stateless Auto is selected
by default.

Static allows to enter the IP address. The Link-Local IPv6 Address
must starts with FE80. The default address is FE80::[Interface ID],
where [Interface ID] is generated from the source MAC address.