Results – EXFO FTB-8500 Series for FTB-200 User Manual
Page 387
Tools Tabs
Ethernet and Fibre Channel Application
373
Trace Route
Timeout (ms): Enter the maximum time allowed between an ICMP
echo and response at each hop. Choices are 200 ms to 10000 ms. The
default setting is 4000 ms.
Max Hop Count: Enter the maximum network device the packet is
allowed to go through. Choices are 1 to 255. The default setting is 128.
Close: Closes the Trace Route configuration window and returns to
the Trace Route page.
Results
To succeed, a Trace Route command shall be acknowledged by the
network device within a given delay. Typically a Trace Route command
can fail for the following reasons:
The IP address is unavailable or unknown.
The time allowed to perform the Trace Route command is too
short.
The remote device is not supporting ICMP messaging.
The Trace Route results are displayed with the following columns:
#: Indicates the attempt number.