EXFO FTB-8500 Series for FTB-200 - Manual (Page 104)

Creating and Starting a Test Case
90 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet BERT Test Case
4. Press the Network node
(available with Framed
Layer 2 only).
4a. Select the IP Version
(IPv4 or IPv6). IP Version
is only available when the
IPv6 software option
(SK-IPV6) is enabled.
4b. For IPv4, select the
Automatic IP Address
check box to dynamically
obtain an IP address from
a DHCP (Dynamic Host
Configuration Protocol)
server.
4c. Set the source and destination IP addresses (based on the
network setting) and if required set the Subnet Mask, and
Default Gateway parameters. Press the Ping button to determine
if the network device is reachable. Refer to IP/UDP/TCP on
page 227 for more information.
4d. If required, set the network source MAC Address. Select the
Resolve MAC Address check box or set the destination MAC
address. Refer to MAC on page 222 for more information.
4e. Select the Frame Format. Choices are Ethernet II and
802.3 SNAP. Refer to Frame Format on page 222 for more
information.
4f. Select the VLAN tab when required and
set the number of stacked VLAN and its
parameters (VLAN Config button). For
more information on VLAN refer to MAC
on page 222.