EXFO FTB-8500 Series for FTB-200 User Manual
Page 84
![background image](/manuals/736440/84/background.png)
Creating and Starting a Test Case
70
FTB-8500 Series and FTB-8120NGE/8130NGE
EtherSAM (Y.1564) Test Case
3. Press the Network node.
3a. If required, set the
network source MAC
address.
Select the Resolve MAC
Address check box or
set the destination MAC
address. The default
destination MAC
address is
FE:FE:FE:FE:FE:FE.
Refer to MAC on
page 222 for more
information.
3b. Select the IP Version
(IPv4 or IPv6). IP
Version is only available when the IPv6 software option (SK-IPV6)
is enabled.
3c. For IPv4, select the Automatic IP Address check box to
dynamically obtain an IP address from a DHCP (Dynamic Host
Configuration Protocol) server.
3d. Set the source and destination IP addresses (based on the
network setting) and if required set the Subnet Mask, and
Default Gateway parameters. Press the Ping button to determine
if the network device is reachable. Refer to IP/UDP/TCP on
page 227 for more information.
3e. Select the Frame Format. Choices are Ethernet II and
802.3 SNAP. For 802.3 SNAP, select the Organizationally Unique
Identifier (OUI). Refer to Network Setup on page 129 for more
information.