EXFO FTB-8500 Series for FTB-200 - Manual (Page 348)

Expert Mode Tabs
334 FTB-8500 Series and FTB-8120NGE/8130NGE
Expert Mode (BERT)
Expert Mode (BERT)
Expert Mode allows the configuration of the thresholds for which each
statistic will be compared to declare a PASS or FAIL verdict.
Press , and Expert Mode.
Enable Expert Mode: Allows enabling/disabling the Expert Mode. This
setting is disabled by default.
Expert Mode Status
Verdict: Gives the verdict, Pass or Fail, of the Port, Ethernet and Pattern
tests according to the Expert Mode settings.
Note: The verdict results are only available when the Expert Mode has been
enabled and when the test is completed or stopped.
Verdict Description
Pass If all result values meet the configured criteria. The FTB-200 front panel Result
Status LED is green.
Fail If any result value does not meet the configured criteria. The FTB-200 front
panel Result Status LED is red.
“--” Is displayed when at least one of the following conditions is met: the Expert
Mode is not enabled, there is no defined criterion, or when the specific test has
not run yet. The FTB-200 front panel Result Status LED is off.