EXFO FTB-8500 Series for FTB-200 - Manual (Page 94)

Creating and Starting a Test Case
80 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
2. For additional configuration parameters, refer to EtherSAM Tabs on
page 279 or RFC 2544 Tabs on page 251.
3. On the local module, press the Start button to start the test. The Start
button will be available only when the connection between the two
FTB-8500 Series and FTB-8120NGE/8130NGE units is established.
Pressing the Start button while in test setup window, will automatically
switch to the first enabled test procedure tab (refer to EtherSAM Tabs
on page 279 or RFC 2544 Tabs on page 251).
At least one of the test procedures (For EtherSAM (Y.1564):
Configuration Test or Performance Test; For RFC 2544: Throughput,
Back-to-Back, Frame Loss or Latency) has to be enabled to start the
test. Test procedures that are enabled will be performed following this
order:
Configuration Test and Performance Test for EtherSAM (Y.1564)
Throughput, Back-to-Back, Frame Loss, and Latency for RFC 2544.
4. For additional results, refer to EtherSAM Tabs on page 279 or RFC 2544
Tabs on page 251.