EXFO FTB-8500 Series for FTB-200 - Manual (Page 242)

Stream Generation Tabs
228 FTB-8500 Series and FTB-8120NGE/8130NGE
IP/UDP/TCP
For IPv6:
Displays the Link-Local IPv6 Address, Global IPv6 Address, and
Default Gateway Address.
IPv6 Config button allows to configure the IPv6 addresses. Refer to
IPv6 Address Configuration for more information.
For both IPv4 and IPv6:

IP Multiplicator:Allows changing the 7 LSB (Least Significant bit) of
the source IP address as specified in the range. This setting is disabled
by default.
Range: Select the IP Multiplicator Range. Choices are 1-128 and 0-127.
The default setting is 1-128.

UDP/TCP - Port: Allows the selection of the source port number.
Choices are 0 to 65535. The default setting is 49184 (public port
number).
Destination

IP Address: Enter the destination IP address for the selected stream.

Ping button: Press Ping to automatically start the quick Ping utility for
the stream destination IP address using the Ping parameters from the
Setup on page 366. Refer to Ping on page 459 for more information.

MAC Address Status: Indicates the resolve MAC address status when
the Resolve MAC Address check box is selected. See page 223 for the
list of possible status.

Resolve MAC Address: When enabled, will send a request to the
network to retrieve the MAC address corresponding to the selected
destination IP address. This setting is disabled by default.

UDP/TCP Port: Allows the selection of the destination port number.
Choices are 0 to 65535. The default setting is 7 (echo).