EXFO FTB-8500 Series for FTB-200 - Manual (Page 109)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 95
Ethernet Frame Analyzer Test Case
3. Press the Network node. The
following parameters apply to
Stream 1.
3a. If required, set the
network source MAC
addresse. Select the
Resolve MAC Address
check box or set the
destination MAC address.
Refer to MAC on page 222
for more information.
3b. Select the IP Version
(IPv4 or IPv6). IP Version
is only available when the
IPv6 software option
(SK-IPV6) is enabled.
3c. For IPv4, select the Automatic IP Address check box to
dynamically obtain an IP address from a DHCP (Dynamic Host
Configuration Protocol) server.
3d. Set the source and destination IP addresses (based on the
network setting) and if required set the Subnet Mask, and
Default Gateway parameters. Press the Ping button to determine
if the network device is reachable. Refer to IP/UDP/TCP on
page 227 for more information.
3e. Select the Frame Format. Choices are Ethernet II and 802.3
SNAP. Refer to Frame Format Configuration on page 453 for more
information.
3f. Press the VLAN tab and select the
VLAN check box when required and
set its parameters. Refer to MAC on
page 222 for more information.