EXFO FTB-8500 Series for FTB-200 - Manual (Page 97)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 83
Ethernet RFC 2544 Test Case
1e. Leave the Dual Test Set check box cleared. For Dual Test Set test
case, refer to Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test
Set Test Cases on page 73.
2. Press the Port node.
2a. Select the Physical Port (Port 1 or
Port 2) that will be used for the
test. The default setting is Port 1.
Available with FTB-8510B only.
2b. Select the port Connector Type
(Optical or Electrical). Connector Type is not available with
Ethernet 10G interface. The default setting is Electrical.
2c. For Electrical, if required, select the Ethernet port crossover
check box to inverse the pin-to-pair assignment of the UTP cable
used.
2d. For Ethernet 10G interface:
Select the Transceiver Mode Choices are Local
Area Network (LAN) for regular Ethernet
interface (10.313Gb/s) and Wide Area Network
for Ethernet stream encapsulated inside a
SONET/SDH frame structure (9.95328Gb/s).
Choices availability depend on the unit model and options refer to
Software Options on page 355 for more information. The default
setting is 10GigE LAN when both transceivers are supported.
For FTB-8120NGE, FTB-8130NGE, FTB-8525, and FTB-8535 with
WAN transceiver mode, select the source Clock Mode . Refer to
Clock Synchronization on page 360 for more information.
2e. For 10/100/1000 interfaces, setSet the Auto-Negotiation, Speed,
Duplex, and Flow Control parameters. Refer to Port Setup on
page 125 for more information.