EXFO FTB-8500 Series for FTB-200 - Manual (Page 82)

Creating and Starting a Test Case
68 FTB-8500 Series and FTB-8120NGE/8130NGE
EtherSAM (Y.1564) Test Case
To create an EtherSAM (Y.1564) test case:
1. Test configuration:
1a. Select
Ethernet 10/100/1000
or Ethernet 10G as the
Interface Type.
Interface Type is not
available with
FTB-8510G.
1b. Select Single Port as
the Topology. Topology
is only available with
FTB-8510B.
1c. Select EtherSAM (Y.1564) as the application type.
1d. Select the desired EtherSAM sub test(s). All EtherSAM sub tests
are selected by default. Refer to Overview (Configuration) on
page 280 and Services (Configuration) on page 285 for more
information.
Configuration Test consists in sequentially testing each service.
It validates that the service is properly provisioned and that all
specific KPIs or SLA parameters are met.
Performance Test simultaneously validates the quality of all the
services over time.
1e. Leave the Dual Test Set check box cleared. For Dual Test Set test
case, refer to Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test
Set Test Cases on page 73.