GMC 2003 Envoy - Manual (Page 114)

Using HomeUnk®
Press and hoJd thO apprppriata Home Li nk'-"-' button for
at least halt ¿>i a second. The indicator ligh! wilt come on
*hlle the signaf is being transmitted.
Erasing HomeLink® Buttons
To erase programming trom the ihiea buttons do ihe
lol lowing:
1 Press end hold down the two outside Duttons until
the tridhcalior light begins to flash, after 20 seconds.
2. Release both buttons. Do not hold for [anger than
30 seconds,
HomeLinK^ is now in the train {learning) mode and can
be programmed at any time beginning with Step 2
under "Programniing HomeLlnk*'."
Individual bullons car^ not be erased, but they can ba
neprogTammed,. See "Reprogramming a Single
HomeLink^' Button" next.
Reprogramming a Single HomeLink®
Button
To program a dewco lo HomeLinK* usmg a HomeLink®
buitan previously framed, loilow these steps
1. Press and hold the desired HomeLmk® button,
Do not release the button
2. The Indicator Jigbl will begin lo flash after
20 seconds While still holding the HomeLInk®'
button, proceed with Step 2 under '■Prograrnn'img
Horn 0 Link*."
Resetting Defaults
To rs> HomeLInk'*^ to default settings do the following:
1, Hold down the two outside buttons tor about
20 seconds until the indicator light begins lo flash.
2. Contmue to hold both buttons until ihe HomeLink*
indioalcr light turns off
3 Reloaso bath buttons.
Far questions or comments, con-tact Home Link'-“' at
1-300-355-3515j or on the internet at
WWW, homellnh.oorn,
2-45