beautypg.com

GMC 2003 Envoy User Manual

Page 112

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Bo surs that people and objects afa clear ot the garage
door Of gale operator you are programming. When
programming a garage dcror, il is advised to park outside
of garage.

It is recommended that a new battery he installed m

your hand-held Iransmitler for quicker and more
accurate transmission of Ihe radio frequency.

Your

vehicfe’s enging should ba turned

off

while

programming ihe

transmitter.

Follow

these slops

to

program Up to three channels^

1. Press and hold down the two outside buttons,

releasing only wh^n the indicator light begins lo
Kash, after 20 seconds. Do not hold down the
buiioos lor longer than gii sEconds and do not
repeat this step to program a second and/oi third
Iransmilter lo the Tsmaining two Home Link®

buttons.

2. Position the ond o( your hand-hefti transmitter

about 1

to 3 inches {3 to 6 cm) away lioni Ihe

HomeLInk® bultgns while keeping the Indicatar
light in VIEW

3.

SimultanEously press

and hold

hctli

the

desired

butlon on

HomeLiPk™

and

Ihe

hand-held

transmitter butlon. Do nol release tha bultoris until
Step 4 has been completed.

Some entry gales and garago dcMt openers may
require you to substitute Step 3 with the procedure
noted In "Gate Operator and Canadian
Programming" later In this secEion.

4, The indicator light will flash slowly al firsl and then

rapidly afler homaLrnk'^ successfully receives the

frequency signal from Ihe hand-held transmitter

Release both buttons.

5. Press and hold the newSy-trained HomeLink^'

button and observe the indicaior light.

If lha indicator itghi stays on conslanti/,

programming fs complete end your device should
activate when Ihe HomeLInk® button is pressed and

released.

To program thg remaining iwo Hom&Link®' buttons,

begin with Step 2 under "Prcgramming
HomeLinii® T Do not repeat Step 1 as this will
erase all of Ihe programmed channels.

11 the indicator light blinks rapidly lor iwo seconds
and thgn turns to fl constani light, continue with
Steps S through

&

following to complete the

programming of a rolling-code equipped

devfCe

{mosl commonly, a garage door opener).

2-43