Cub Cadet I-Beam Style User Manual
Page 98
3-79
3
15.Remove and discard the zip tie securing the
clutch control cable to the lower handle bar.
16.Remove the T-knob, flat washer, and hex
screw from the depth stake. See Figure 3-228.
17.Remove the hairpin and clevis pin securing the
depth stake to the tine shield bracket.
18. Remove the depth stake.
19.Remove both hex cap screws and flange lock
nuts from the handle brackets using two 1/2"
wrenches and two 9/16” wrenches. See Figure
3-229.
NOTE
DO NOT remove the lower rear hex cap screw
and flange lock nut securing the handle brack-
ets and spacer.
20.Remove the handle assembly from the unit.
21.Place chocks in front of the wheels to keep
them from rolling. See Figure 3-230.
22.Place the tiller in gear using a center drift
punch for leverage.
23.Tilt the tiller forward and place a jack-stand
under the center of the gear case assembly.
24.Remove the plastic wing nuts securing the side
tine shield covers and adjustable tine shields.
25.Remove the side tine shield covers and adjust-
able tine shields.
Tillers.fm Page 79 Tuesday, February 19, 2002 1:28 PM