Cub Cadet I-Beam Style - Manual (Page 251)

6-52
3. Remove, inspect, and replace the adjustable
gibs if necessary. See Figure 6-58.
4. Assemble the left Gib adjustment assembly in
the reverse order above leaving the tensioning
hex cap screws and hex jam nuts loose.
5. Tighten the tensioning hex cap screws equally
until they are snug using a 9/16" wrench.
6. Slowly back off the tensioning hex cap screws
until the wedge assembly slides across the full
travel area.
7. Hold the hex cap screws in place with a 9/16"
wrench, and secure the hex jam nuts up
against the floating gib plate using a 9/16"
wrench.
8. Grasp the wedge assembly and make certain it
moves freely across the full travel area of the
beam assembly.
NOTE
There should be less then 1/16th inch tol-
erance between the adjustable gibs and the
side of the beam assembly.
Figure 6-58.
Log Splitters 2.fm Page 52 Wednesday, February 20, 2002 1:35 PM