Cub Cadet I-Beam Style - Manual (Page 75)

3-56
NOTE
DO NOT remove the lower rear hex cap screw
and flange lock nut securing the handle brack-
ets and spacer.
2.Locate and align the lower handle assembly
mounting holes with the holes in the handle
brackets.
3.Secure the lower handle assembly to the han-
dle brackets with the hex cap screws and
flange lock nuts removed earlier, using two
1/2" wrenches and two 9/16” wrenches.
NOTE
The smaller hex cap screw is inserted in the
front mounting hole.
Clutch Cable Installation
1.Route the clutch cable up the left side of the
handle assembly.
2.Loosen the jam nut securing the eyebolt to the
threaded cable end using a 7/32” wrench and a
3/8” wrench. See Figure 3-155.
3.Unscrew and remove the eyebolt from the
threaded cable end.
4.Slide the threaded cable end up through the
center of the upper handle assembly mounting
hole and snap the retainer in place. See Figure
3-156.
NOTE
Spread the outer retainer tabs using a small
flat-blade screwdriver.
5.Thread the eyebolt into the threaded cable end
several turns. See Figure 3-157.
Tillers.fm Page 56 Tuesday, February 19, 2002 1:28 PM