Cub Cadet I-Beam Style - Manual (Page 81)

3-62
b.The shift cover label clearly states the gear the
tiller is in, and what direction the tines will
rotate. See Table 3-6 below.
NOTE
Never engage the clutch bail while shifting.
Depth Stake and Side Shield Positions
WARNING
When operating the tiller for the firsttime, use
the depth stake setting that gives 1 inch of till-
ing depth (second hole from top). See Figure
3-172.
1.The tilling depth is controlled by the depth
stake that can be adjusted to five different set-
tings.
NOTE
The side shields must be adjusted along with
the depth stake. See Figure 3-173.
2.To adjust the depth stake, remove the hairpin
and clevis pin.
3.Move the depth stake up or down to the
desired height and secure it into place.
4.To adjust the side shields, remove the front
wing nut and loosen the rear wing nut.
5.Pivot the side shields to the desired position and
secure the wing nuts.
Tillers.fm Page 62 Tuesday, February 19, 2002 1:28 PM