Cub Cadet I-Beam Style - Manual (Page 83)

3-64
9. Loosen the center lock jam nut and hex cap
screw securing the idler belt keeper to the idler
pulley.
10.Remove the V-belt from the unit.
11.Install a new belt in the reverse order above.
NOTE
Make certain the V-belt is installed properly
between the pulleys and the belt keepers.
12.Perform all Clutch Cable Adjustments prior to
operating the tiller.
Problem Solving Pathfinder
Problem: Wheels Do Not Rotate Under Power
Exterior Gear Case Assembly Inspection
1.Are the hairpins and clevis pins securing the
wheel assemblies to the wheel shafts? See
Figure 3-176.
a.Fix: Install hairpins and clevis pins.
2.Does the shift lever lock into each gear selec-
tion? See Figure 3-177.
a. Fix: Proceed to the Interior Gear Case Assem-
bly Inspection.
3.Is the spiral pin securing the indicator bracket
to the shift lever? See Figure 3-178.
a.Fix: Install a new spiral pin.
4. Is the clutch control cable adjusted properly?
See Figure 3-179.
Tillers.fm Page 64 Tuesday, February 19, 2002 1:28 PM