Cub Cadet I-Beam Style - Manual (Page 106)

3-87
3
NOTE
Perform the Tiller Gear Case Assembly
Removal and the Gear Case Separation sec-
tions prior to performing wheel shaft assembly
removal.
1.Remove the large thrust washer and wide 30T
forward tine idler gear assembly from the jack
shaft. See Figure 3-259.
2.Remove the large thrust washer and 30T spur
gear from the center jack shaft.
3.Grasp the 18T tine shaft assembly and 9T tine
input sprocket assembly and raise both until
the 9T tine input sprocket assembly comes
free of the center jack shaft assembly. See Fig-
ure 3-260.
4.Pivot the 9T tine input sprocket assembly and
#50 chain away from the center jack shaft
assembly. See Figure 3-261.
NOTE
Loosening the hex nuts and bell-washers
securing the jack shafts to the gear case
assembly will ease installation.
Tillers.fm Page 87 Tuesday, February 19, 2002 1:28 PM