Cub Cadet I-Beam Style - Manual (Page 118)

4-9
4
3. Rotate impeller assembly by hand until you
locate one of the chipper blades in the chipper
chute opening. Remove blade using a 3/16
inch allen wrench on the outside of the blade
and 1/2 inch wrench on the impeller assembly
inside the housing. See Figure 4-17.
4. Remove the other blade in the same manner.
5. Replace or sharpen blades.
NOTE
If sharpening, make certain to remove an
equal amount from each blade.
6. Reassemble blades with the sharp edge facing
the slotted opening in impeller assembly.
7. Reassemble shredder in reverse order.
CHIPPER SHREDDER VACUUM.fm Page 9 Tuesday, February 19, 2002 2:19 PM