Cub Cadet I-Beam Style - Manual (Page 71)

3-52
7.Remove three spacers. See Figure 3-97.
8.Lift out spur gear from jackshaft. Clean and
inspect spur gear for any damage; replace if
necessary. See Figure 3-140.
9.Lift out spur gear assembly #50 chain and tine
shaft assembly. Clean and inspect gears for
any damage. Replace if necessary.
10.Remove the 30 and 44 tooth spur gear and flat
washer. Clean and inspect gears for any dam-
age. Replace if necessary.
11.Remove gear hub. See Figure 3-141.
NOTE
Carefully retain flat spacer washer on top of
the 30 and 44 tooth spur gear assembly. This
is necessary for proper gear spacing.
12.Lift out wheel shaft assembly, 55 tooth spur
gear assembly and #420 chain. Clean and
inspect all parts for damage. Replace if neces-
sary. See Figure 3-142.
13.Remove detent shaft assembly and 16 tooth
spur gear assembly. Clean and inspect parts
for damage. Replace if necessary. See Figure
3-143.
Tillers.fm Page 52 Tuesday, February 19, 2002 1:28 PM