Cub Cadet I-Beam Style - Manual (Page 31)

3-15
3
NOTE
The drive system has 3 chain reduction steps.
Each step reduces the speed and increases
the torque or power down to the axle shaft. The
reduction is done with the use of the #41 chain
to a #420 chain to a #50 chain.
7.Remove the middle #420 chain by lifting off
one end from sprocket bearing sleeve assem-
bly and the other end from sprocket shaft. See
Figure 3-34.
8.Remove the second #50 chain from tine shaft.
The sprocket bearing sleeve assembly can
also be removed. See Figure 3-35.
NOTE
The chain case is lubricated with 16 ounces of
plastilube #0 grease to keep the bearings and
chains operating in a constant lubrication bath.
9.To disassemble hub sprocket assemblies, slide
spacer out of bearing. On an arbor press
remove bearing by placing a spacer or similar
tool on the OD of bearing and press out. See
Figure 3-36.
10.To remove tine shaft assembly simply pull
complete assembly out of housing. See Figure
3-37.
Tillers.fm Page 15 Tuesday, February 19, 2002 1:28 PM